Medusa (S) DMT
The Marchetti Medusa SDMT is the enhancement of the Medusa DMT with Seismic sensors in true interval configuration for the measurement of the shear wave velocity Vs. The seismic module is mounted above the DMT blade and incorporates two horizontal seismic receivers spaced 0.5 m apart. A Shear-Wave source is struck at the ground surface, and the two receivers measure the arrival of the wave. From the time difference between the two receivers, the system calculates shear-wave velocity Vs.
So you get everything from the Medusa DMT, plus:
Vs — Shear Wave Velocity
and therefore:
G₀ — Small-strain shear modulus
This is particularly valuable because the DMT gives you soil stiffness at working/operative strain levels, while the Seismic measurement gives you stiffness at very small strain. Marchetti specifically highlights that combining these provides two points on the soil’s G–γ stiffness degradation curve.
Medusa SDMT shouldn’t be confused with the traditional SDMT. The traditional SDMT combines a conventional pneumatic DMT with the seismic module, whereas Medusa SDMT combines the automated hydraulic Medusa system with the Seismic module. Marchetti describes Medusa SDMT as the newer evolution incorporating both automated DMT and Seismic measurements.
Full Set
The full set contains all the necessary components for testing down to 50m of depth. The set includes one Probe, the Medusa SDMT acquisition unit for automatic logging of DMT and S-wave readings, 50m cable, Membranes, Auxiliary Components, Medusa Software and SDMT Pro Software and the mandatory training. For deeper testing longer cables may be supplied on request. The probe may operate also offshore up to over 1000m of water depth.

Use with Penetrometer
The Medusa probe can be pushed into the ground with a penetrometer such as the Pagani Geotechnical CPTu Rigs, Geomil CPTu Rigs and other penetrometers however the digital cable to be used with the Medusa unit must be a Pagani 4 pin cable or Geomil 6 pin cable configuration. The Medusa can be purchased with the correct adaptor to connect the Medusa with your type of CPT Rods. Typical options are displayed below with the A2 thread being the most common for Pagani and Geomil users.
Use with a Drilling Rig
The Medusa probe can be pushed into the ground using a traditional drilling rig by utilising the Marchetti “Torpedo” system. The Torpedo system allows the rig to push the Medusa probe and a string of purpose-built rods and cable into the soil to a given depth. Once the length of the Torpedo system is reached the system must be retracted and removed entirely from the soil to allow for drilling to occur. The borehole drilling will stop just short of the end of the first Medusa push. From there the drilling equipment is removed and the Medusa probe and Torpedo system are connected to the drill rods and lowered into the borehole. The Medusa test can be resumed at the end of the last test depth. This process is repeated until target depth is reached for the DMT/SDMT test. Note casing maybe required if the ground is unstable.
Data Capture
All data is captured on the users Laptop as the Medusa probe is connected to the Marchetti Interface Unit via the digital cable and the Interface Unit is then connected to the Laptop via a USB connection. The software that comes with the Medusa kit will have already been installed onto the Laptop and live data is presented and recorded. Testing is controlled by the user of the Laptop.



